Removing And Installing Gearbox Housing And Selector Mechanism - Volkswagen Golf Variant 2007 Workshop Manual

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
5.3

Removing and installing gearbox housing and selector mechanism

1 - Countersunk bolt, 33 Nm
2 - Flange shaft with compres‐
sion spring
❑ Removing and installing
⇒ page 227
❑ Assembling
⇒ page 233
3 - Retaining ring
❑ For sealing cover
⇒ Item 4 (page 130)
❑ Fitted from gearbox
date 21 01 8
4 - Cover plate
❑ Secured with retaining
ring from gearbox date
21 01 8
❑ Allocate components
according to ⇒ Elec‐
tronic parts catalogue
„ETKA" .
5 - Retaining ring
❑ For deep groove ball
bearing of input shaft
⇒ Item 1 (page 180)
6 - Reversing light switch -F4- ,
20 Nm
❑ Changed to captive seal
shortly after introduction
of gearbox
⇒ Item 7 (page 130)
7 - Seal
❑ Not fitted in all gearbox‐
es
❑ Always renew
8 - Oil drain plug
❑ Torque setting ⇒ page 127
9 - Seal
❑ Always renew
10 - Locking bolt, 45 Nm
❑ For selector shaft
11 - Bolt, 15 Nm + turn 90° further
❑ Bolt with captive washer only as replacement part
❑ Always renew; allocate shim according to ⇒ Electronic parts catalogue „ETKA"
❑ Allocation of bolts as replacement part
12 - Bolt, 15 Nm + turn 90° further
❑ Without washer
❑ Always renew; allocate shim according to ⇒ Electronic parts catalogue „ETKA"
❑ Allocation of bolts as replacement part
13 - Selector unit
❑ (Selector shaft with selector shaft cover)
130
Rep. gr.34 - Controls, housing
.
⇒ page 131
⇒ page 131