Volkswagen Golf Variant 2007 Workshop Manual page 187

Pulling cylinder roller bearing out of clutch housing
– When pulling out, squeeze together retaining ring -arrow- of
cylindrical roller bearing, using pliers -C-.
A - Counter support , e.g. -Kukko 22/2-
B - Internal puller, 30 ... 37 mm , e.g. -Kukko 21/5-
Pressing cylindrical roller bearing into clutch housing
– When pressing in, squeeze together retaining ring -arrow- of
cylinder roller bearing, using pliers -A-.
– Remove pliers before cylindrical roller bearing is in installation
position. Retaining ring must engage in groove of clutch hous‐
ing.
1.1.1 Modification in area of deep groove ball
bearing
From gearbox date 10 04 6 through around gearbox date 20 01 8:
One washer above and one below bearing seat for deep groove
ball bearing ⇒ Item 6 (page 180)
Above bearing seat:
Bearing seat
Through gearbox Dimension „a" = 10
date 09 04 6
From gearbox date
10 04 6
through around
gearbox date
20 01 8:
From around gear‐ Below bearing seat:
box date 21 01 8 flat for deep groove
Beneath bearing seat:
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
.
Washer above bear‐
mm
Dimension „a" =
10.7 mm
ball bearing
6-speed manual gearbox 02Q - Edition 06.2010
ing seat
no
yes
no
183
1. Input shaft