Volkswagen Golf Variant 2007 Workshop Manual page 140

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-speed manual gearbox 02Q - Edition 06.2010
5.5.1 Removing
– Secure gearbox to assembly stand using bolts -arrows-.
Note
If one of the bolting holes does not contact the gearbox support ,
lay a washer between the hole and the gearbox support .
– Rotate gearbox on assembly stand so that oil drain plug is
below.
– Place drip tray underneath.
– Drain gear oil.
– Remove slave cylinder with clutch release bearing -arrows-.
During the following steps, ensure that the selector shaft is not
blocked by the angled rod -arrow-.
– Move selector shaft to neutral.
– Remove reversing light switch -F4- -1-.
– Remove locking bolt -2-.
– Then remove bolts -3-.
– Pull selector shaft with selector shaft cover -4- out of gearbox
housing.
– Remove securing bolt for left and right flange shaft by screwing
two bolts into flange and counterholding using a lever.
– Pull out flange shafts with compression spring.
136
Rep. gr.34 - Controls, housing