Enabling Test Patterns - Christie H Series User Manual

2. To enable edge blending, select Enable.
3. In the Start list, enter the start of the blending area and press Enter.
4. In the Width list, enter the width of the blending area and press Enter.
When setting the blending width make sure the edge blending marker is superimposed on the
other blending marker.
5. To enable the marker function, select Enable Marker.
6. To change the marker of the blending area, right-click on the Start color box and select a
color.
7. Right-click on the End color box and select a color.
The blending area is set in the center box.
8. Repeat steps 2 to 7 for the Left, Right, and Bottom edge blending areas.
9. To enable the gamma function, in the Gamma section, select Enable.
10. To control the gamma curve of the blending area, enter a value and press Enter.
For adjacent projectors make sure the gamma value is the same.
11. To revert to the default settings, click Reset.

Enabling test patterns

Use the test patterns to assist with tuning edge blending.
1. In the Projector Control dialog, switch to the Edge Blending tab.
2. In the Test Pattern section, select Enable.
3. To change the color of the test pattern, right-click on one of the color boxes and select a
color.
4. Repeat step 3 for the other color box.
H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual
020-000807-02 Rev. 1 (07-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Warping and blending
7