5. Install a clean air filter with the airflow indicator pointing toward the projector.
6. Replace the cover.
Clean the liquid cooling air filter
This filter is located on the operator side near the rear of the projector, behind a small air filter
cover. The Liquid Cooling filter is an electrostatic reusable filter. Check the condition of this filter
monthly.
1. Shut down the system.
See
Shut down for maintenance
2. Remove LVPS/liquid cooling cover.
3. Loosen the two screws (#2 Phillips) that secure the filter retaining bracket.
4. Slide the retaining bracket away from the filter.
5. Push downwards on the top of the filter so it clears the clip.
6. Pull the filter out and wash it.
CP42LH User Guide
020-101363-03 Rev. 1 (08-2016)
on page 68.
Maintenance
77