Filtration; Replace The Light Engine Air Filter; Replace The Liquid Cooling Air Filter - Christie Mirage 4K35 User Manual

Hide thumbs Also See for Mirage 4K35:

Table of Contents

Filtration

Notice. Failure to comply with the following may result in property damage.

Use only high efficiency Christie approved filters: light engine filter (five-pack)—P/N:003-001184-XX,

liquid cooling radiator filter—P/N: 003-003082-XX, and LAD filter (three-pack)—P/B:03-001982-51P.

Never operate the projector without the filter installed. The air filters in this product cannot be

cleaned thoroughly enough for reuse and can lead to the contamination of optical components.

This filter is located on the lens side of the projector behind the air filter cover. Check the condition

of this filter monthly. Replace the light engine air filter when replacing the lamp, or sooner when

operating the projector in a dusty or dirty environment.

1. Release the two tabs on the air filter cover.

2. Lift up the cover enough for the bottom tabs to clear the frame and remove.

3. Slide the air filter out from behind the air filter cover and discard.

4. Insert the new air filter with the airflow indicator facing toward the projector.

This ensures proper particle filtration.

5. To complete the installation, align the bottom tabs and repeat these steps in reverse order.

This filter is located on front lamp-side of the projector, behind a small air filter cover. Check the

condition of this filter monthly. Replace the liquid cooling air filter when refilling the liquid cooling

module, or sooner when operating the projector in a dusty or dirty environment.

1. Release one tab on the air filter cover.

2. Rotate the top towards you and lift up to remove.

3. Slide the air filter out and discard.

4. Insert the new air filter with the airflow indicator facing toward the projector.

5. Install the air filter cover.

Mirage 4K35 User Manual

020-101377-03 Rev. 1 (07-2015)

Maintenance

Table of Contents