Managing The Mpx200 For Xp 24000/20000; Setting Up The Mpx200 Management Port; Use The Blade # Command; The Admin Start Command - HP StorageWorks MPX200 User Manual

4 Managing the MPX200 for XP
24000/20000

Setting up the MPX200 management port

Access to the MPX200 CLI is required for initial setup. Connect to the CLI through one of the following:
• RS-232 serial port (115200/8/n/1)
• Telnet
• Secure Shell (SSH)
By default, the management port obtains a Dynamic Host Configuration Protocol (DHCP) address. If
the management port cannot obtain a DHCP address, you must set a static IP address. Static IP
addresses are highly recommended to retain connectivity.
Once connected, select the desired blade to manage by using the blade <1 or 2> command (see
Figure 31).
Figure 31 Use the blade # command
.
Use the admin start command to change settings (see
Figure 32 The admin start command
.
Figure 32).
MPX200 Multifunction Router User Guide 47