Dodge 2000 DURANGO Service Manual page 65

DN
DISASSEMBLY AND ASSEMBLY (Continued)
(6) Flip the propeller shaft yoke and install the
bearing cap onto the opposite trunnion. Install a
snap ring (Fig. 30).
Fig. 30 Press In Bearing Cap
(7) Fit the link yoke on the remaining two trun-
nions and press both bearing caps into place (Fig.
31).
(8) Install snap rings.
Fig. 31 Install Link Yoke
(9) Install the centering kit assembly inside the
link yoke making sure the spring is properly posi-
tioned (Fig. 32).
Fig. 32 Install Centering Kit
(10) Place two bearing caps on opposite trunnions
of the remaining cross. Fit the open trunnions into
the link yoke bores and the bearing caps into the
centering kit (Fig. 33).
Fig. 33 Install Remaining Cross
PROPELLER SHAFTS 3 - 15