Dodge 2000 DURANGO Service Manual page 64

3 - 14 PROPELLER SHAFTS
DISASSEMBLY AND ASSEMBLY (Continued)
(7) Flip assembly and repeat Step 4, Step 5, and
Step 6 to remove the opposite bearing cap. This will
then allow removal of the cross centering kit assem-
bly and spring (Fig. 26).
Fig. 26 Remove Centering Kit
(8) Press the remaining bearing caps out the other
end of the link yoke as described above to complete
the disassembly.
ASSEMBLY
During assembly, ensure that the alignment
marks on the link yoke and propeller shaft
yoke are aligned.
(1) Apply extreme pressure (EP) N.L.G.I. Grade 1
or 2 grease to inside of yoke bores to aid in installa-
tion.
(2) Fit a cross into the propeller shaft yoke (Fig.
27).
Fig. 27 Install Cross In Yoke
(3) Place a bearing cap over the trunnion and
align the cap with the yoke bore (Fig. 28). Keep the
needle bearings upright in the bearing assembly. A
needle bearing lying at the bottom of the cap will
prevent proper assembly.
Fig. 28 Install Bearing Cap
(4) Press the bearing cap into the yoke bore
enough to install a snap ring (Fig. 29).
(5) Install a snap ring.
Fig. 29 Press In Bearing Cap
DN