How To Remove The Diskette Drive - Sun Microsystems Enterprise 250 Owner's Manual

What Next
To reassemble the system, complete these tasks:
4 "How to Install the Removable Media Assembly (RMA)" on page 132
4 "How to Install the Side Access Panel" on page 62
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your system
is able to recognize the new device(s). For additional information, see:
4 "How to Initiate a Reconfiguration Boot" on page 58

How to Remove the Diskette Drive

Before You Begin
Complete these tasks:
4 "How to Power Off the System" on page 55
4 "How to Remove the Side Access Panel" on page 60
4 "How to Avoid Electrostatic Discharge" on page 64
4 "How to Remove the Removable Media Assembly (RMA)" on page 128
Video Demonstration
Figure 7–17
Click on the icon above for a video demonstration.
Click here for Appendix E.
What to Do
1. Disconnect the diskette data cable and the removable media power cable from
the rear of the diskette drive.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
144