Sun Microsystems Enterprise 250 Owner's Manual page 142

Figure 6–6
2. Align the module with its socket until it contacts the socket evenly along the
socket's length.
3. Push firmly down on both ends of the module until the bottom edge is firmly
seated in the socket.
Ensure that all module contacts engage in the socket.
What Next
Complete this task to reassemble the system:
4 "How to Install the Side Access Panel" on page 62
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your system
is able to recognize the new device(s). For additional information, see:
4 "How to Initiate a Reconfiguration Boot" on page 58
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
108