Sun Microsystems Enterprise 250 Owner's Manual page 157

How to Remove the NVRAM/TOD
Module
Caution -
This procedure must be performed by a qualified service-trained
maintenance provider. Persons who remove any of the outer panels to access this
equipment must observe all safety precautions and comply with skill level
requirements, certification, and all applicable local and national laws.
Before You Begin
Complete these tasks:
4 "How to Power Off the System" on page 55
4 "How to Remove the Side Access Panel" on page 60
4 "How to Avoid Electrostatic Discharge" on page 64
What to Do
1. Locate the NVRAM/TOD module on the main logic board.
The NVRAM/TOD module is located at board address U2706.
2. Grasp the NVRAM/TOD carrier assembly by the edges and pull out the
NVRAM/TOD module.
Place the NVRAM/TOD module on an antistatic mat.
Removing and Installing Main Logic Board Components
123