Sun Microsystems Enterprise 250 Owner's Manual page 193

4. Remove the Phillips screw that secures the LED/keyswitch assembly to the
front of the chassis.
Figure 8–9
5. Pull the top part of the assembly away from the chassis and lift the bottom tab
free from the slot in the chassis wall.
6. Carefully pull the assembly and its attached cables out through the openings in
the chassis wall.
Open the disk access door, if necessary, to gain better access to the LED ribbon
cable.
What Next
To replace the LED/keyswitch assembly, complete this task:
4 "How to Install the LED/Keyswitch Assembly" on page 160
Removing and Installing Miscellaneous Assemblies
159