Sun Microsystems Enterprise 250 Owner's Manual page 150

Figure 6–13
3. Secure the PCI card faceplate to the rear panel with the Phillips screw.
4. If necessary, connect any internal cables to the PCI card's internal connectors.
Read the documentation supplied with the PCI card for information about
jumper settings, PCI slot requirements, and cable connections.
5. If necessary, connect any external cables to the PCI card.
Read the documentation supplied with the PCI card for information about
external cable connections.
What Next
Complete the following tasks to reassemble the system:
4 "How to Install the Side Access Panel" on page 62
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your system
is able to recognize the new device(s). For additional information, see:
4 "How to Initiate a Reconfiguration Boot" on page 58
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
116