Sun Microsystems Enterprise 250 Owner's Manual page 299

The probe-scsi command transmits an inquiry command to all SCSI devices
connected to the main logic board SCSI interfaces. This includes any tape or
CD-ROM drive in the removable media assembly (RMA), any internal disk drive,
and any device connected to the external SCSI connector on the system rear panel.
For any SCSI device that is connected and active, its target address, unit number,
device type, and manufacturer name are displayed.
The probe-scsi-all command transmits an inquiry command to all SCSI devices
connected to the system SCSI host adapters, including any host adapters installed in
PCI slots. The first identifier listed in the display is the SCSI host adapter address in
the system device tree followed by the SCSI device identification data.
The first example that follows shows a probe-scsi output message. The second
example shows a probe-scsi-all output message.
probe-scsi output:
ok probe-scsi
This command may hang the system if a Stop-A or halt command
has been executed. Please type reset-all to reset the system
before executing this command.
Do you wish to continue? (y/n) n
ok reset-all
ok probe-scsi
Primary UltraSCSI bus:
Target 0
Unit 0 Disk SEAGATE ST34371W SUN4.2G3862
Target 4
Unit 0 Removable Tape
Target 6
Unit 0 Removable Read Only device TOSHIBA XM5701TASUN12XCD0997
Target 9
Unit 0 Disk SEAGATE ST34371W SUN4.2G7462
Target b
Unit 0 Disk SEAGATE ST34371W SUN4.2G7462
ok
probe-scsi-all output:
ok probe-scsi-all
This command may hang the system if a Stop-A or halt command
has been executed. Please type reset-all to reset the system
before executing this command.
Do you wish to continue? (y/n) y
/pci@1f,4000/scsi@4,1
Target 2
Unit 0 Disk SEAGATE ST32550W SUN2.1G0418
Target 3
Unit 0 Disk SEAGATE ST32550W SUN2.1G0418
Target 4
Unit 0 Disk SEAGATE ST32550W SUN2.1G0418
Target 5
Unit 0 Disk SEAGATE ST32550W SUN2.1G0418
Target 8
ARCHIVE Python 02635-XXX5962
Diagnostics and Troubleshooting
265