Sun Microsystems Enterprise 250 Owner's Manual page 151

How to Remove the SSP Paddle Card
The System Service Processor (SSP) paddle card is mounted in the top slot opening
in the system's rear panel.
Before you Begin
Complete these tasks:
4 "How to Power Off the System" on page 55
4 "How to Remove the Side Access Panel" on page 60
4 "How to Avoid Electrostatic Discharge" on page 64
Video Demonstration
Figure 6–14
Click on the icon above for a video demonstration.
Click here for Appendix E.
What to Do
1. Disconnect any cables from the external faceplate of the SSP card.
2. Remove the Phillips screw that secures the card faceplate to the system rear
panel.
Use a magnetized screwdriver, if possible, to prevent the screw from falling into
the system chassis. Save the screw for when you install the replacement SSP card.
Removing and Installing Main Logic Board Components
117