Sun Microsystems Enterprise 250 Owner's Manual page 216

How to Install the UltraSCSI Backplane
What to Do
1. Slide the UltraSCSI backplane into the backplane slot in the base of the disk
cage assembly.
Orient the backplane so that the six SCSI drive connectors are facing the open
drive bays.
2. Insert the six posts at the rear of the disk cage into the corresponding keyholes
in the backplane. Lift the backplane slightly so that each post rests in the
narrow part of a keyhole.
Figure 9–3
3. Push the cage center divider back into the disk cage as far as it can go.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
182