Sun Microsystems Enterprise 250 Owner's Manual page 202

Figure 8–16
6. Stand the whole chassis upright.
Enlist the help of another person to accomplish this safely.
7. Finish tightening the two captive screws at the top of the disk cage.
8. Grasp the corner of the LED ribbon cable (hanging in front of the disk bay
opening), and fold the cable under itself, so that the label at the end is facing
up.
9. Feed the end back into the disk bay opening and route it on top of the disk
cage toward the upper-left corner of the UltraSCSI backplane.
Arrange the middle portion of the cable so that it lies flat across the top of the
disk cage at the front of the chassis.
10. Reconnect the LED ribbon cable to connector J0602 at the front of the
UltraSCSI backplane.
This connector is located in the upper-left corner of the backplane (as viewed
from the front). Make sure that the label at the end of the cable faces up. Press
down the connector collar to secure the connection.
11. Reconnect the remaining cables to the rear of the UltraSCSI backplane:
a. Connect the UltraSCSI data cable to connector J0102.
b. Connect the UltraSCSI power cable to connector J0101.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
168