How To Remove A Pci Card - Sun Microsystems Enterprise 250 Owner's Manual

5. Simultaneously push both levers toward the center of the CPU module until it
is fully seated in its connector.
What Next
Complete the following task to reassemble the system:
4 "How to Install the Side Access Panel" on page 62
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your system
is able to recognize the new device(s). For additional information, see:
4 "How to Initiate a Reconfiguration Boot" on page 58

How to Remove a PCI Card

Before you Begin
Complete these tasks:
4 "How to Power Off the System" on page 55
4 "How to Remove the Side Access Panel" on page 60
4 "How to Avoid Electrostatic Discharge" on page 64
Video Demonstration
Figure 6–9
Click on the icon above for a video demonstration.
Click here for Appendix E.
What to Do
1. Disconnect any external cable(s) from the external faceplate of the PCI card.
2. Disconnect all cables connected to the PCI card internal connectors.
3. Remove the Phillips screw that secures the faceplate to the system rear panel.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
112