Sun Microsystems Enterprise 250 Owner's Manual page 238

5. Connect the other end of the cable to the appropriate network device.
There are a variety of connector and cabling options available for the AUI
connection. See your network administrator if you need more information about
how to connect to your network.
Note -
connect to the main logic board's TPE and MII ports at the same time. For
information about connecting to the TPE port, see "How to Attach a Twisted-Pair
Ethernet (TPE) Cable" on page 200.
What Next
If you are installing your system, then complete the installation procedure. Return to:
4 "How to Install the Enterprise 250 Server" on page 44
If you are adding an additional interface to your system, then you need to configure
that interface; see:
4 "How to Add an Ethernet Interface" on page 198
How to Boot the System Using the
Standard Ethernet Interface
Before You Begin
Before you can boot the system over a network interface, you must complete the
installation procedure; see:
4 "How to Install the Enterprise 250 Server" on page 44
Specifically, you must perform the following tasks:
4 Set up a system console; see "About Setting Up a Console" on page 49
4 Configure the Ethernet port; see "How to Configure the Standard Ethernet
Interface" on page 196
4 Attach the Ethernet port to a network; see "How to Attach a Twisted-Pair
Ethernet (TPE) Cable" on page 200 or "How to Attach an MII Ethernet
Transceiver" on page 202
4 Power on the system; see "How to Power On the System" on page 56
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
204
You can use only one of the main logic board Ethernet ports. You cannot