Sun Microsystems Enterprise 250 Owner's Manual page 170

4. Attach the antistatic wrist strap to a metal surface inside the system chassis.
5. Identify the disk drive to be removed and note the bay in which it is installed.
For information about disk status LEDs, see "About Internal Disk Drives" on
page 83.
6. Using your thumb and forefinger, push the drive latch upward to release the
drive handle.
Swing the handle out away from the drive until you feel the drive connector
disengage from the backplane.
Figure 7–9
7. Holding the drive by the handle, slide it out of the drive bay.
Place the drive on an antistatic mat.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
136