Sun Microsystems Enterprise 250 Owner's Manual page 194

How to Install the LED/Keyswitch
Assembly
Video Demonstration
Figure 8–10
Click on the icon above for a video demonstration.
Click here for Appendix E.
What to Do
1. Unlock the disk access door and swing it open.
2. Grasp the cables attached to the LED/keyswitch assembly and feed them
through the appropriate openings in the front of the chassis.
Feed the keyswitch cable through the small round opening and the LED ribbon
cable through the rectangular opening below it.
3. Route the keyswitch cable straight back toward the UltraSCSI backplane.
4. Thread the LED ribbon cable straight down behind the chassis wall and pull it
out through the disk bay opening.
5. Insert the bottom portion of the LED/keyswitch assembly into the rectangular
opening at the front of the chassis.
Position the assembly so that the bottom tab rests inside the chassis.
6. Replace the Phillips screw that secures the top portion of the assembly to the
chassis wall.
7. Reattach the RMA plastic cover to the front of the removable media assembly.
Align the clips on either side of the cover with the small rectangular slots in the
chassis wall. Push evenly on both sides of the cover to secure it to the chassis.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
160