Obdiag Commands - Sun Microsystems Enterprise 250 Owner's Manual

Figure 12–2

OBDiag Commands

The following table provides information about the OBDiag interactive commands
that are available at the OBDiag command prompt:
TABLE 12–1
Command Description
Exits the OBDiag tool and returns to the ok prompt.
exit
Displays a brief description of each command and OpenBoot PROM
help
variable used to run OBDiag.
Displays the value of all of the OBDiag variables. (See "OBDiag
printenvs
Configuration Variables" on page 242 for information about settings.)
Sets the value for an OpenBoot PROM configuration variable. (See
setenv variable
"OBDiag Configuration Variables" on page 242 for information about
value
settings.)
Runs all of the tests displayed in the menu.
test-all
Runs only the test(s) identified by menu entry number (#) in the
test #,#,
command line.
Diagnostics and Troubleshooting
241