Sun Microsystems Enterprise 250 Owner's Manual page 79

2. Ensure that the system's front panel keyswitch is in the Standby position.
See "About the Status and Control Panel" on page 6.
3. Connect the AC power cord to the power inlet at the rear of the power supply.
Connect the other end to a grounded AC power outlet.
The outlet must connect the system to a 15A circuit for North America and Japan,
and to a 10A circuit for Europe. See your local electrical codes.
Insert the female end of the power cord through the plastic tie-wrap loop located
to the right of the supply. Tighten the tie-wrap to secure the connection.
Figure 3–1
Note - If your server includes a second power supply, connect its AC power cord
in the same manner. You may connect the second power supply to the same
circuit as the first supply. However, for increased system redundancy, you should
connect the two power supplies to separate circuits.
4. Install any optional components shipped with your system.
Many of the options ordered with your system may have been pre-installed at the
factory. However, if you ordered options that were not factory-installed, see the
following sections for installation instructions:
45
System Setup