Sun Microsystems Enterprise 250 Owner's Manual page 181

Pinch the two metal retainers together to release the filler panel from the front of
the RMA enclosure.
2. If necessary, remove the plastic filler panel from the RMA plastic cover.
Squeeze the two retainer posts together to release the filler panel from the RMA
plastic cover.
3. Slide the diskette drive into the diskette drive bay.
Align the two screw holes on each side of the diskette drive with the
corresponding holes in each side of the diskette drive bay.
Figure 7–21
4. Insert and tighten the four flat-head Phillips screws that secure the drive in
its bay.
5. Connect the removable media power cable to the power connector at the rear of
the diskette drive.
The connector is keyed and only fits one way.
6. Connect the diskette data cable to the data connector at the rear of the drive.
The connector is keyed and only fits one way.
Removing and Installing Storage Devices
147