Sun Microsystems Enterprise 250 Owner's Manual page 173

7. Holding the drive by its handle, fit the drive into the guide rails at the top and
bottom of the drive bay.
8. Slide the drive into the bay until it barely contacts the backplane.
9. Press carefully on the center of the drive and watch as the handle begins to
close.
The drive handle begins to close as the drive engages its backplane connector.
10. Press the handle toward the drive until the latch closes, securing the drive
in place.
11. Close the disk access door and lock it if necessary.
12. If you are performing a hot-plug installation, complete the software part of the
installation procedure.
See "About Internal Disk Drives" on page 83.
What Next
If you have other parts to replace in the system, do so now.
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. You must also perform a reconfiguration boot so that your system
is able to recognize the new device(s). For additional information, see:
4 "How to Initiate a Reconfiguration Boot" on page 58
How to Remove a CD-ROM Drive or
Tape Drive
Before You Begin
Complete these tasks:
4 "How to Power Off the System" on page 55
4 "How to Remove the Side Access Panel" on page 60
4 "How to Avoid Electrostatic Discharge" on page 64
4 "How to Remove the Removable Media Assembly (RMA)" on page 128
Removing and Installing Storage Devices
139