Sun Microsystems Enterprise 250 Owner's Manual page 235

What to Do
1. Locate the RJ-45 connector for the appropriate Ethernet interface.
The system comes with one TPE connector on the rear panel. Your system may
also include one or more additional TPE connectors provided via PCI Ethernet
interface cards.
2. Plug in the TPE cable to the appropriate RJ-45 connector.
You should hear the connector tab snap into place.
Figure 10–1
3. Plug in the other end of the cable to the TPE outlet in the wall or the floor.
You should hear the connector tab snap into place.
See your network administrator if you need more information about how to
connect to your network.
Note - You can use only one of the main logic board Ethernet ports. You cannot
connect to the main logic board's TPE and MII ports at the same time. For
information about connecting to the MII port, see "How to Attach an MII
Ethernet Transceiver" on page 202.
What Next
If you are installing your system, complete the installation procedure. Return to:
4 "How to Install the Enterprise 250 Server" on page 44
Administration and Networking
201