How To Power On The System; Before You Begin - Sun Microsystems Enterprise 250 Owner's Manual

2. Back up the system files and data, if necessary.
3. Halt the operating system using the appropriate commands.
Refer to the Solaris Handbook for SMCC Peripherals that corresponds to your
operating system.
4. Wait for the system halt messages and the ok prompt.
5. Turn the keyswitch on the front panel of the system to the Standby position,
which is fully counterclockwise.
Figure 4–1

How to Power On the System

Before You Begin

If a terminal or local console is not already connected to the system, you need to
install one before continuing the startup procedure.
4 See "About Setting Up a Console" on page 49.
Sun Enterprise 250 Server Owner's Guide ♦ Revision A, June 1998
56