Remote Programming - Teletek electronics ECLIPSE 16 Engineer Programming Manual

6.3 Remote programming

The parameters for up / download programming of the integrated digital communicator are set on ADDRESSES 69хх.
The remote control parameters are available only for ECLIPSE 32 control panel.
ADDRESS
UDL
OPERATION
TELEPHONE
TEXT MENU
Setting a telephone number for remote control
A Telephone number for remote control via ProsTE software is assigned at the address.
The set telephone number for remote programming is active only when option 1. CALL BACK is
enabled at ADDRESS 6904!
The telephone number must not exceed 32 characters. Some special functions can be entered by
using the next button combinations:
1. Buttons
2. Buttons
3. Buttons
4. Buttons
5. Buttons
screen.
6. Buttons
Note: The
functionality.
Default setting: none
ADDRESS
PC ID OPERATION
TEXT MENU
Personal computer identification number for up/ down loading.
The PC ID number for up / down loading is configured at this address. Four digits can be introduced.
Valid are symbols 0 to 9. The entered number is saved with pressing the ENTER button.
Default setting: 1234
6900
690
8. COMMUNICATION – 1. DIGITAL COMM – 6. UDL – 1. PHONE
+ 0 - Switches on "pulse dialer". "P" letter is displayed on the screen.
/
+ 1 - Switches on "tone dialer". "T" letter is displayed on the screen.
/
+ 2 - 2 seconds pause. "D" letter is displayed on the screen.
/
+ 3 - Switches on "Wait dial tone". "" symbol is displayed on the screen.
/
+ 4 - "Blind dialing"; Switches off "Wait dial tone". "#" symbol is displayed on the
/
+ 5 - Deletes the entered telephone number.
/
button is used in the previous design of the keyboards and has the same
6901
691
8. COMMUNICATION – 1. DIGITAL COMM – 6. UDL – 2. PC ID
Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
71