Teletek electronics ECLIPSE 16 Engineer Programming Manual page 66

Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
ADDRESS
ATTEMPTS OPERATION
TEXT MENU
Number of attempts for communication with monitoring station
The Engineer sets the number of attempts to connect to the central station for telephone monitoring
and the number of repetitions of voice messages at the address. Use the digit numbers to enter a
value from 1 to 9. The value "0" disables the operation and the communicator will not dial a number.
The value assigned at this address is the number of attempts to be made for each of the telephones,
configured at addresses 60xx – "xx" is a number of a phone (01-04 for ECLIPSE 32 and 01-02 for
ECLIPSE 8/ 16).
If the assigned value is 4 and there are two telephone numbers set at addresses 6010 and 6020, the
number of attempts that will be made are 8 – by 4 attempts for each telephone number.
After the assigned number of attempts for communication is reached, the attempts to transmit voice
messages will be terminated. The attempts to transmit will be renewed to the central station first,
when the next transmission event occurs.
Default setting: 4 attempts
ADDRESS
TEST
OPERATION
PERIOD
TEXT MENU
Test message period
Duration of transmission of test message in hours (HHH) from 000 to 255 is entered.
Three digits must be entered. When entering a period shorter than 10 hours the first two digits must
be 0.
Default setting: 024 hours
ADDRESS
TEST
OPERATION
HOUR
TEXT MENU
Test message hour
At this address is set the first hour, at which the test message will start to be transmitted to central
monitoring station. Hours and minutes are entered (HH:MM), as the entered time is the time of
starting the first test.
The next test time will start after the assigned at ADDRESS 6002 test period.
Default setting: [00:05]
ADDRESS
TLM
OPERATION
DELAY
TEXT MENU
Telephone line monitor fault delay
A delay of 000 to 255 minutes is set prior to indication of a telephone line failure. Three digits must
be entered. When entering a period shorter than 10 minutes the first two digits must be 0.
Default setting: [000] minutes
6001
601
8. COMMUNICATION – 1. DIGITAL COMM – 2. ATTEMPTS
6002
602
8. COMMUNICATION – 1. DIGITAL COMM– 3. TEST MESSAGES – 2. PERIOD
6003
603
8. COMMUNICATION – 1. DIGITAL COMM – 3. TEST MESSAGES – 1. TIME
6004
604
8. COMMUNICATION – 1. DIGITAL COMM – 4. FAULT DELAY
66