System Programming; Sounder Delay - Teletek electronics MAG8Plus Installation And Operation Manual

In order to connect the sounder circuits:
• Shut down the mains supply and disconnect the terminals of the power unit to the
battery.
• One by one remove the resistors (R=10K) from the sounder connecting clamps
(SND1÷SND4) on the main module and connect them in parallel to the last sounder of
each of the circuits. Connecting the sounders to outputs of 4-sounder expander is done
in an analogical manner.
• Connect the sounder circuits to the SND1÷SND4 clamps on the main module and/or on
the 4-sounder expander by observing the polarity.
• Connect the battery to the power unit and apply the main power supply.
After powering up the panel should be in normal operation mode
!
and the "Power Supply 230v" LED lights up on the front panel of
MAG8Plus.
NOTE: If the GENERAL FAULT LED lights up on the front panel together with any of
the FAULTS LEDs of the main module and/or the 4-sounder expander - SND1÷SND4,
perhaps there is a problem in the connection. Check the polarity of the connection to
the terminal of the main module of the panel, as well as the connection to the 4-sounder
expander.

5. SySTEM PROGRAMMING

5.1 Sounder Delay

This is an option for setting a delay on the Sounders activation when the panel enters
"Fire" mode. The indication on the front panel - the FIRE LED, however, will light up
immediately in case of a fire event, regardless of whether a delay has been set to enable
the sounders. After the programmed delay period expires, during which the user can
possibly find out the cause for the alarm event, the panel enables the sounders. The
sounders can be silenced by pressing the
panel.
In case of a false fire alarm the user must press the
working mode.
Attention: The fire alarm panel MAG8Plus is capable to distinguish the activation of
automatic fire alarm detector and call point. In case of call point activation, the programmed
sounder time delay will be ignored and the sounders will be activated immediately.
In order to program MAG8Plus for Sounder Delay over an interval between 1 and
10 minutes:
• Examine the Table of Instructions for programming sounder delay, shown on
Figure 10.
• Depending on the selected time delay, set a jumper at the TIME DELAy
terminals, marked in Figure 10 as 1, 2, 3, and 4.
• Press
Example: In order to program sounder delay of 3 minutes, set jumpers on positions 1
and 2.
18
MAG8Plus - Installation and Operation Manual
to introduce changes.
(see item 6.2) on the front
button to return to normal