Teletek electronics ECLIPSE 16 Engineer Programming Manual page 29

ADDRESS
CODE
OPERATION
LENGTH
TEXT MENU
Code digits length
The system allows using 4 and 6 digits codes: engineer, maintenance and users.
Every pressing of a digital button or the arrows alternatively changes the digits number. The set
parameter is confirmed with ENTER button.
At this address is assigned:
4 digits
6 digits
When switching from 4- to 6-digits code, the digits 00 will automatically be added at the end. For
example, the 4-digits code 1234 will become 123400.
When changing over from 6- to 4-digits code, only the first four figures in the 4-digits code
will remain valid. For example, the 6-digits code 123456 will become 1234. Due to risk of
coincidence of codes, changing over from 6- to 4-digits code IS NOT RECOMMENDED!
Default setting: 4 digits
ADDRESS
CODE
OPERATION
CLONE
TEXT MENU
User Codes Cloning
This is an address for coping (cloning) of attributes, rights, areas, time slots and control options for
card readers for user codes. The user access codes are not automatically cloned – they have to be
assigned for every one user separately from the Manager's programming menu.
The information for cloning is set in three digit sections with the following meaning:
1001>CODE CLONE
[01]> [10] [20]
Source
Code
It is possible to clone only serial number of codes. If it is necessary to clone parameters to one user
code only, then enter 00 or the same user code in the "Last Code to clone" field. Press the ENTER
button to start the cloning procedure.
Example:
1001>CODE CLONE
[03]> [04] [10]
The source code is the User Code 03 and its parameters will be programmed in the settings of User
Codes from 04 to 10 inclusive.
1000
100
3. CODES – 3. CODE LENGTH
The Engineer, maintenance and users are using 4 digit access codes.
The Engineer, maintenance and users are using 6 digit access codes.
1001
101
3. CODES – 4. CODE CLONE
First Code Last Code
to clone to clone
Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
Source Code – This is the source code which parameters
will be copied.
First Code to clone – This is the first code number to
which the parameters of the source code will be assigned.
Last Code to clone – This is the last code number to
which the parameters of the source code will be assigned.
29