Voice Dialer - Teletek electronics ECLIPSE 16 Engineer Programming Manual

6.2 Voice Dialer

The programming of the following addresses concerns the operation of the ECLIPSE 8/ 16/ 32 control panels with
mounted voice dialer.
ADDRESS
VD
OPERATION
OPTIONS
TEXT MENU
Programming of option for the voice dialer
The options are common for all programmed telephone numbers. Use the digit buttons 1 and 2 to
set the option numbers. Every pressing of the button changes alternatively the option status.
At this address you set the following options:
1
2
Indication:
LCD: In the text menus the option is enabled with pressing button "1" – a check mark appears in
front of the text.
LED: Press a digit button corresponding to the number of the option. The zone numbers
corresponding to the enabled options are lighting on.
Default setting: All options are disabled
ADDRESS
VD
OPERATION
MSG REP.
TEXT MENU
Programming of number for message repetitions for the voice dialer
The Engineer sets the number for message repetition for the voice dialer in this address. Set a value
from 0 to 9. When setting value 0, the dialer will send the message for events occurrence without
repeating it; when the value 1 is set, the dialer will send the message for events occurrence and will
repeated it ones, and so on. The entered value is confirmed with ENTER button.
Default setting: [3]
ADDRESS
VD
OPERATION
DIAL REP
TEXT MENU
Programming of number for dialing attempts for the voice dialer
The Engineer sets the number of dialing attempts to the telephone numbers set at addresses 61x0,
where "x" is phone number, for the voice dialer. Use the digit numbers to enter a value from 1 to 9.
When setting the value 0, the dialer will make only one attempt to dial the set phone numbers; when
the set value is 1 – two attempts, and so on. The entered value is confirmed with ENTER button.
Default setting: [3]
6100
670
8. Communication – 2. Voice Dialer – 1. VD Options
Sending a Sending of a report upon occurrence of an event.
Disable () – The report sending is disabled.
report for
Enable (1) – The dialer will send rapport upon occurrence of an event to the
event
programmed phone numbers at addresses 61x0, where "x" is phone number.
User User management via external telephone line.
Disable () – The user management is disabled.
management
Enable (2) – The user management is enabled – see also the algorithm for
user management in APPENDIX 4.
6101
671
8. Communication – 2. Voice Dialer – 2. VD Message Rep.
6102
672
8. Communication – 2. Voice Dialer – 3. VD Dial Rep.
Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
69