General Parameters - Teletek electronics ECLIPSE 16 Engineer Programming Manual

6.1 General Parameters

At ADDRESSES 60хх are programmed common parameters of the connected to the system communication devices.
ADDRESS
DIGITAL
OPERATION
COMM
TEXT MENU
Setting of communication options
The options are common for programmed telephone numbers.
Use the digit buttons to set the option numbers. Every pressing of the button changes alternatively
the option status.
Pay attention that for some options both of the statuses are used – see the description of the options
in the table below. The option number 3 is not available for ECLIPSE 8/ 16 control panel.
At this address you set the following options:
1
2
3
4
5
6
7
8
Default setting:
6000
600
8. COMMUNICATION – 1. DIGITAL COMM – 1. OPTIONS
Dialer Enable / Using of the voice dialer (ECLIPSE VD) and the build-in digital
Disable communicator (PSTN):
Disable () – The communication devices are disabled (not used).
Enable (1) – The communication devices are enabled.
Note: When the option 1 is enabled and no voice dialer is mounted to the
control panel's PC, the panel transmits a melody sound signal upon
occurrence of an ALARM event.
TLM Enable / Enabling of Telephone Line Monitoring (TLM):
TLM Disable () – The TLM is disabled.
Disable
TLM Enable (2) – The TLM is enabled and in case of telephone line fault
the trouble message "4. Tel. line trouble" is generated.
TLM ALARM Generating of alarm event in case of telephone line failure:
TL ALARM Disable () – No alarm message is generated in case of
Enable / Disable
telephone line failure.
TL ALARM Enable (3) – An alarm message is generated in case of
telephone line failure.
Tone / Pulse Option for the type of dialing:
TONE () – Tone type dialing.
PULSE (4) – Pulse type dialing.
Enabling of "Wait dial tone" signal check:
Dial Tone / Blind
DIAL TONE () – The "Wait dial tone" signal check is enabled.
dialing
BLIND DIALING (5) – The "Wait dial tone" signal check is disabled. The
"Blind dialing" is enabled.
ALL / Alternative Option for setting the algorithm of sending alarm messages:
ALL () – The messages are sent to all set telephone numbers, starting
with the first recorded one.
ALTERNATIVE (6) – If the messages are successfully sent to the first
recorded phone number, the rest of the phone numbers are not dialled. If
the message transmission to the first phone number is failed, the system
will try to dial the next recorded phone number and so on until a
successful message transmission is achieved.
Note: If the alarm events are assigned to different telephone numbers,
the setting of this option does not matter. In that case independent
message report to different telephone numbers is realized - "SPLIT
Report".
REPORT Channels for sending messages
CHANNELS The options 7 and 8 are set in combination to define the used report
channel:
7


7
7
5. Blind Dialing, 6. Alternative, 7, 8
Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
8

No communication through AJAX and PSTN channels
8 AJAX is the main channel, and PSTN is backup channel

PSTN is the main channel, and AJAX is backup channel
8 Both channels are used
65
Channel