Led Indication For The System Status; Buttons For Programming And Operation; Switch For Changing The Access Levels - Teletek electronics MAG8P Installation And Operation Manual

Fire Control Panel MAG8 - Installation and Operation Manual

1.4 LED indication for the system status:

LED
FIRE
(red)
GENERAL FAULT
(yellow)
OUTPUT DELAY
(yellow)
µP FAULT
(yellow)
sOUNDER FAULT/DIsABLE
(yellow)
ENABLE / DIsABLE
(yellow)
TEsT
(yellow)
POWER sUPPLY 230v
(green)

1.5 Buttons for programming and operation:

Button
sILENCE BUZZER
sILENCE ALARM
ENABLE / DIsABLE Enabling / Disabling of Zones / Sounders.
TEsT / sCROLL
REsET
sOUND ALARM
1.6 switch for changing over between Access Levels 1 and 2:
Position
OFF
Access Level 1 - only the "SILENCE BUZZER" button is active.
ON Access Level 2 - all buttons at the front panel are active.
6
Fire in the premises.
Main Fault indicator.
Lights permanently at programmed outputs time delay
(a jumper is set on the TIME DELAY terminal).
Processor break down.
Trouble in the sounder circuit - open or short circuit;
reverse connected sounder.
Lights permanently at disabled zones/sounders. Blinks
during enabling/disabling of zones or sounders.
Blinks during "One Man" Test together with the LED
of the tested zone.
Lights on permanently in normal operating mode,
indicates presence of main power supply 230V.
Deactivating the internal buzzer.
Deactivating sounders.
Test mode; Scroll forward zones.
Initialization; Confirm the introduced changes.
Activating sounders.
Description
Indication
Description