Teletek electronics ECLIPSE 16 Engineer Programming Manual page 53

Deactivated on "OR" function (if at least one
system trouble is present)
49-54 Not used
Event No Special Events - Description
Engineer menu entry
55
The PGM is activated in Engineer menu
ENG. MENU
entry.
ENTRY
The PGM is restored in Engineer menu exit.
56 - 58 Not used
"Chime" Sound Signal
59
Activated on "OR" function (there is "Chime"
CHIME
activated in at least one area)
EVENT
Deactivation on time - 5 sec.
Video on armed
60
Activated in case of violation in an instant
VIDEO ON
zone with "Video on armed" set option.
ARMED
Deactivation on time – 1 minute.
Fire Detector Reset
The PGM is activated when the Memory log
61 file is cleared after entering of valid codes
FIRE RESET with rights for operation in the respective
area.
Deactivation on time - 5 sec.
Time slot activation
62
Follows the activation of the respective time
TIME SLOT
slot number.
PGM Timer
63*
This only deactivation event. After the set
time is over the PGM is restored.
64 Remote control
Remote activation and deactivation
CONTROL (restore) of the PGM output.
Remote access
Remote Arming and Disarming of the PGM
65
output via communication module - AJAX,
REMOTE
VD/DTMF, ARGUS and the digital
ACCESS
communicator. Remote control via ProsTE
software.
66
ALARM OR
ENTRY TIME
Alarm or entry time
67-72 Not used
* Note: The events are not available in revision number 1.8x.
A limited event numbers are available in ECLIPSE 8/ 16 control panel. The panel supports events numbers:
20, 21, 27, 37, 39, 47, 61, 64 and 66. Note that event number 66 is available in ECLIPSE 8/ 16 control panel.
Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
4 – Tel. line or communication
failure
5 – Tamper
6 – System bus error
7 – Fire line failure
8 – Siren fault
All system troubles are
enabled by default.
-
PARAMETERS 1
-
-
-
-
-
Enter a time slot number from
1 to 8.
Enter time in interval 000-255
seconds/ minutes units.
-
-
-
-
53
-
PARAMETERS 2
-
-
-
-
-
-
-
-
-
-