Teletek electronics ECLIPSE 16 Engineer Programming Manual page 68

Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
2
3
4
5
6
7
8
Default setting: All messages enabled
ADDRESS
PH1
OPERATION
AREAS
TEXT MENU
Associating of areas to Telephone 1 of the digital communicator
According the system configuration the engineer associates one or several AREA numbers for
operation with Telephone 1. To select an AREA press the digit button corresponding to its number.
The next pressing of the same button will deselect the AREA.
To select all areas press button "0" – the button alternatively switches over all enabled / all disabled
state.
The Telephone 1 will be inactive if there are no associated areas to it!
Default setting: AREA 1
The second telephone number for ECLIPSE 8/ 16 and from 2 to 4 for ECLIPSE 32 are programmed in an analogical
way.
TAMPER
PANIC, AMBUSH CODE
FIRE
ARM, DISARM, BYPASS
MEDICAL
TROUBLE
SPECIAL
6013
613 + 01
8. COMMUNICATION – 1. DIGITAL COMM – 5. PHONES – 1. PHONE – 4. ATTACH
Message is sent in case of events:
- TAMPER (from a zone; from a Tamper type zone; from a
device connected to the system bus: keyboard, proxy reader,
expander modules)
- TAMPER Restore
Message is sent in case of events:
- PANIC (from a zone; from a keyboard)
- Entered AMBUSH CODE
Message is sent in case of events:
- FIRE (from a zone; from a keyboard)
- FIRE Restore
Message is sent in case of events:
- ARMING
- DISARMING
- ZONE BYPASS
Message is sent in case of events:
- MEDICAL ALARM
- MEDICAL ALARM Restore
Message is sent in case of the troube/ trouble restore events:
1. AC Lost/ failure
2. Battery Lost/ Failure
3. Fuse Blown
4. Communication Lost
5. Error on the system bus
Message is sent in case of events:
Keyboard lockout
-
- Engineer menu entry
- Engineer menu exit
- Download start
- Download end
- Periodic Test Report
- Manual Test Report
- Power Up
- Reset
- Time Changed
- Absent (device)
- Restored (device)
- User Code Change
68