Programming Types; Programming Via Proste Software; Programming Via Panel's Keyboard; Firmware Update - Teletek electronics REPEATER Installation And Programming Manual

Repeater – Installation and Programming Manual

3. PROGRAMMING TYPES

3.1. Programming via ProsTE Software

The specialized ProsTE software is designed for programming of intruder and fire alarm panels produced by
Teletek Electronics JSC. To program the Repeater panel you should first to install the ProsTE software on your
computer – the program can be downloaded free of charge after registration on the website of the producer:
http://www.teletek-electronics.com/en/product/proste-en
To program the Repeater panel you have to use cable type USB Micro B - USB A.
Figure. Programming via Pros TE software

3.2. Programming via Panel's Keyboard

The Repeater can be programmed directly using the keyboard on the front panel. The programming and
settings are accessed from levels 2 (Maintenance) and 3 (Installer). The buttons on the front panel are
organized in three main groups
• Functional digit buttons – used for entry in submenus, changing parameter status, entering of
new combination for Maintenance and Installer access codes.
• Navigation buttons – arrows for moving the cursor on the screen and switching over the editable
fields, confirmation of entered parameters, cancelation of entered parameters and step back in the
menu programming structure.
• Specialized buttons for User operation – Silence buzzer, Silence sounders, Reset, Evacuation,
General test of the LEDs, buzzer and screen.
The detailed description of all buttons on the front panel is presented in item 2.1.1 – , page. 6
The detailed description of Maintenance and Installer programming access levels is presented in item 5.

3.3. Firmware Update

ATTENTION!
The firmware update of the main microprocessor of the Repeater should be performed by
qualified personnel only and after held training program by the producer Teletek Electronics JSC!

3.3.1 Firmware Update from Computer

To start a firmware update from a computer you should first to have a copy of an image update file (with *.bin
extension) saved on your computer. For firmware updates use the USB_UTG connector on the main PCB:
➢ Connect the panel to the computer using USB cable: Normal A to Micro B type.
➢ Enter access code for level 2 or 3 and choose menu 6) SOFT. VERSION.
➢ Wait for the message from Windows Explorer for found new Removable Disk.
1. Copy image file to Removable Disk
2. Make Eject at Removable Disk
> Panel is configured
6 9
8