Displaying Qos Status; Displaying A Class Map - Allied Telesis AT-8100L/8 User Manual

To Do This Task
Displays the mappings of CoS priority
values to egress queues of a specified
port.
Displays the mappings of DSCP values
to egress queues of a specified port.
Displays the mapping between the
existing DSCP value and the new
DSCP value.
Displaying QoS
Status
Displaying a
Class Map
Table 232. QoS Display Commands (Continued)
show mls qos maps cos-queue
show mls qos maps dscp-queue
show mls qos maps policed-dscp
To display the status of the QoS feature, use the SHOW MLS QOS
command at the Global Configuration mode. The command syntax is:
show mls qos
See Figure 258 for an example of this command when QoS is disabled.
For more information about this command, see "SHOW MLS QOS" on
page 1667.
Qos is disabled
Figure 258. SHOW MLS QOS Command
To display the contents of a class map, use the SHOW CLASS-MAP
command in the Privileged Exec mode. Here is the command syntax
followed by an example display:
awplus# show class-map cmap2
See Figure 259 for an example of this command.
CLASS-MAP-NAME: cmap2
Set IP DSCP: 56
Match IP DSCP: 7
Figure 259. SHOW CLASS-MAP Command
AT-8100 Switch Command Line User's Guide
Use This Command
<0-63>
1685