AT-8100 Switch Command Line User's Guide
PASSIVE-INTERFACE
Syntax
passive-interface
vlanid
Parameters
vlanid
Specifies the ID number of a VLAN.
Mode
Routing Configuration
Description
Use this command to prevent the transmission of routing updates through
the routing interface in the specified VLAN. The routing interface in the
VLAN does not receive routing updates, but the network that the specified
VLAN belongs to is still advertised.
Confirmation Command
"SHOW IP RIP" on page 1891
Example
The following example blocks the transmission of routing updates through
the routing interface in VLAN 8:
awplus> enable
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# passive-interface vlan8
1889