Storm-Protection - Allied Telesis AT-8100L/8 User Manual

AT-8100 Switch Command Line User's Guide

STORM-PROTECTION

Syntax
storm-protection
Parameters
None
Mode
Policy Map Class
Description
Use this command to enable the Policy-Based Storm Protection feature.
Storm protection is activated as soon as a port is enabled.
Use the no form of the command, NO STORM-PROTECTION, to disable
the Storm Protection feature.
Confirmation Command
"SHOW MLS QOS INTERFACE STORM-STATUS" on page 1794
Examples
The following example enables the Storm Protection feature on class map
"cmap1:"
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap1
awplus(config-pmap-c)# storm-action linkdown
awplus(config-pmap-c)# storm-protection
The following example disables the Storm Protection feature on class map
"cmap3:"
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap3
awplus(config-pmap-c)# storm-action vlandisable
awplus(config-pmap-c)# no storm-protection
1799