Deleting Server Ip Addresses; Displaying The Radius Client - Allied Telesis AT-8100L/8 User Manual

Deleting Server
IP Addresses
Displaying the
RADIUS Client
To delete the IP address of a RADIUS server from the list of servers on the
switch, use the NO RADIUS-SERVER HOST command in the Global
Configuration mode. You can delete only one IP address at a time with this
command. This example removes the IP address 211.132.123.12 from the
list of RADIUS servers:
awplus> enable
awplus# configure terminal
awplus(config)# no radius-server host 211.132.123.12
To display the settings of the RADIUS client, use the SHOW RADIUS
command in the User Exec mode or Privileged Exec mode.
awplus# show radius
Here is an example of the RADIUS client information.
RADIUS Global Configuration
Source Interface
Timeout
Server Host : 192.168.1.75
Authentication Port : 1812
Accounting Port
Figure 246. SHOW RADIUS Command
The information is described in Table 156 on page 1508.
AT-8100 Switch Command Line User's Guide
: 192.168.20.33
: 5 sec
: 1813
1481