Egress Queue Shaping; Table 220. Using The Set Queue Command - Allied Telesis AT-8100L/8 User Manual

Chapter 100: Quality of Service (QoS)
Egress Queue
Shaping
1668
The following example uses the SET QUEUE command to set the traffic
classified by class map "cmap4" to queue 6 within policy map "pmap3:"

Table 220. Using the SET QUEUE Command

Command
awplus> enable
awplus# configure
terminal
awplus(config)# mls qos
enable
awplus(config)# class-map
cmap4
awplus(config-cmap)# exit
awplus(config)# policy-
map pmap3
awplus(config-pmap)#
class cmap4
awplus(config-pmap-c)#
set queue 6
In addition to setting egress port queues, you may want to configure
egress queue shaping to further refine the queues. This section discusses
how to set the following values on an egress queue:

Bandwidth transmission rate

Scheduling method
 Transmission limit
Description
Enters the Privileged Executive mode
from the User Executive mode.
Enters the Global Configuration mode.
Activates the QoS feature on the
switch.
Creates a class map called "cmap4"
and enters the Class Map mode.
Exits the Class Map mode.
Creates a policy map called "pmap3."
Adds class map "cmap4" to policy map
"pmap3."
Sets traffic classified by class map
"cmap4" to queue 6.