Set Queue - Allied Telesis AT-8100L/8 User Manual

SET QUEUE

Syntax
<0-7>
set queue
Parameters
<0-7>
Specifies the queue.
Mode
Policy Map Class mode
Description
Use this command to set the egress queue of the classified traffic.
Use the no form of this command to remove the egress queue from a
policy map.
Note
You cannot use the SET QUEUE command and the SET COS
command as policy map actions for the same class map.
Confirmation Command
"SHOW RUNNING-CONFIG" on page 164
Examples
The following example sets the egress queue to 6 for traffic classified by
class map "cmap4:"
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# class-map cmap4
awplus(config-cmap)# exit
awplus(config)# policy-map pmap3
awplus(config-pmap)# class cmap4
awplus(config-pmap-c)# set queue 6
AT-8100 Switch Command Line User's Guide
1757