Match Protocol; Table 236. Layer Two Ethernet Formats - Allied Telesis AT-8100L/8 User Manual

MATCH PROTOCOL

Syntax
eth-format layer-two-format protocol layer-three-
match
protocol
Parameters
eth-format
Indicates the following parameter is a Layer 2 Ethernet format.
layer-two-format
Specifies the Layer 2 Ethernet format. For a list of entries, see
Table 236.
protocol
Indicates the following parameter is a Layer 3 protocol.
layer-three-protocol
Specifies the Layer 2 Ethernet protocol. For a list of entries, see
Table 237 on page 1716.
Mode
Class Map mode
Description
Use this command to set one Ethernet format and one protocol as a
matching criteria for a class map. You can also assign one Ethernet format
or one protocol to a class map with this command.
See "NO MATCH PROTOCOL" on page 1742 for information about how to
remove an Ethernet format and protocol from a class map.

Table 236. Layer Two Ethernet Formats

Parameter
802dot2-tagged
802dot2-untagged
ethii-tagged
ethii-untagged
netwareraw-tagged
netwareraw-untagged
AT-8100 Switch Command Line User's Guide
Description
Indicates 802.2 tagged packets.
Indicates 802.2 untagged packets.
Indicates Ethii tagged packets.
Indicates Ethii untagged packets.
Indicates NetWare Raw tagged packets.
Indicates NetWare Raw untagged packets.
1715