Storm-Downtime - Allied Telesis AT-8100L/8 User Manual

Chapter 103: QSP Commands

STORM-DOWNTIME

Syntax
<1 - 86400>
storm-downtime
Parameters
<1 - 86400>
Indicates the number of seconds.
Mode
Policy Map Class
Description
Use this command to set the time, in seconds, the port is reenabled after
being disabled by the QSP feature. The default is 10 seconds.
Use the no form of the command, NO STORM-DOWNTIME, to return the
number of seconds to the default value.
Confirmation Command
"SHOW MLS QOS INTERFACE STORM-STATUS" on page 1794
Examples
The following example sets the downtime to 2 minutes:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap1
awplus(config-pmap-c)# storm-action vlandisable
awplus(config-pmap-c)# storm-protection
awplus(config-pmap-c)# storm-downtime 120
The following example returns the default downtime to 10 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap1
awplus(config-pmap-c)# storm-action linkdown
awplus(config-pmap-c)# storm-protection
awplus(config-pmap-c)# no storm-downtime
1798