No Match Protocol - Allied Telesis AT-8100L/8 User Manual

Chapter 101: Quality of Service (QoS) Commands

NO MATCH PROTOCOL

1742
Syntax
eth-format layer-two-format protocol layer-three-
no match
protocol
Parameters
eth-format
Indicates the following parameter is a Layer 2 Ethernet format.
layer-two-format
Specifies the Layer 2 Ethernet format. For a list of entries, see
Table 236 on page 1715.
protocol
Indicates the following parameter is a Layer 3 protocol.
layer-three-protocol
Specifies the Layer 3 Ethernet protocol. For a list of entries, see
Table 237 on page 1716.
Mode
Class Map mode
Description
Use this command to remove an Ethernet format and a protocol as a
matching criteria for a class map. You can also remove one Ethernet
format or one protocol from a class map with this command.
Confirmation Command
"SHOW RUNNING-CONFIG" on page 164
Examples
The following example removes an Ethernet format of snap untagged
packets and the AppleTalk protocol from a class map called "cmap1:"
awplus> enable
awplus# configure terminal
awplus(config)# class-map cmap1
awplus(config-cmap)# no match eth-format snap-untagged
protocol appletalk