Table 218. Setting Egress Cos Queues Example - Allied Telesis AT-8100L/8 User Manual

Command
awplus> enable
awplus# configure terminal
awplus(config)# mls qos enable
awplus(config)# class-map trustcos
awplus(config-cmap)# exit
awplus(config)# policy-map pmap1
awplus(config-pmap)# class trustcos
awplus(config-pmap-c)# exit
awplus(config-pmap)# exit
awplus(config)# interface port1.0.8
awplus(config-if)# service-policy
input pmap1
awplus(config-if)# mls qos map cos-
queue 5 to 7
awplus(config-if)# end
awplus# show mls qos maps cos-queue
interface port 1.0.8
The following example sets ingress traffic with a CoS value of 5 to egress
on queue 7 of port 8:

Table 218. Setting Egress CoS Queues Example

Description
Enters the Privileged Executive mode from the
User Executive mode.
Enters the Global Configuration mode.
Activates the QoS feature on the switch.
Creates a class map called "trustcos" and enters
the Class Map mode.
Exits the Class Map mode.
Creates a policy map called "pmap1."
Adds class map "trustcos" to policy map "pmap1."
Exits the Policy Map Class mode.
Exits the Policy Map mode.
Enters the Port Interface mode for port 8.
Attaches policy map "pmap1" to port 8.
Maps priority 5 to queue 7 on port 8.
Exits the Port Interface mode.
Displays the CoS mapping for port 8. See below.
COS:01 2
--------------------------------
QUEUE:20 1
AT-8100 Switch Command Line User's Guide
34567
34567
1665