Chapter 98: Advanced Access Control Lists (ACLs)
awplus> enable
awplus# configure terminal
awplus(config)# interface
port1.0.5
awplus(config_if)# no mac access-
group 4037
Removing Named
IPv4 ACLs
awplus> enable
awplus# configure terminal
awplus(config)# interface
port1.0.22
awplus(config_if)# no access-
group protodeny
Removing Named
IPv6 ACLs
1544
This example removes a MAC ACL with an ID number of 4037 from port 5:
Table 180. Removing MAC Address ACLs Example
Command
To remove a Named IPv4 ACL from a port on the switch, use the NO
ACCESS-GROUP command with the list_name parameter in the Port
Interface mode. Here is the format of the command:
no access-group
For more information about this command, see "ACCESS-GROUP" on
page 1562.
The following example removes a Named IPv4 ACL called "protodeny"
from port 22:
Table 181. Removing Named IPv4 ACLs Example
Command
To remove a Named IPv6 ACL from a port on the switch, use the NO IPV6
TRAFFIC-FILTER command in the Port Interface mode. Here is the format
of the command:
no ipv6 traffic-filter <
For more information about this command, see "IPV6 TRAFFIC-FILTER"
on page 1626.
Description
Enter the Privileged Executive mode from
the User Executive mode.
Enter the Global Configuration mode.
Enter the Port Interface mode for port 5.
Remove MAC ACL 4037 from port 5.
list_name
Description
Enter the Privileged Executive mode from
the User Executive mode.
Enter the Global Configuration mode.
Enter the Port Interface mode for port 22.
Remove Named IPv4 ACL called
"protodeny" from port 22.
ipv6_access_list
>