Mls Qos Map Dscp-Queue - Allied Telesis AT-8100L/8 User Manual

Chapter 101: Quality of Service (QoS) Commands

MLS QOS MAP DSCP-QUEUE

1734
Syntax
mls qos map dscp-queue
Parameters
dscp_value
Specifies a DSCP value. The lowest value is 0, and the highest
value is 63. You can map more than one value level to an egress
queue, but you can specify only one value level at a time with this
command.
egress_queue
Specifies an egress queue number of 0 through 7. The lowest
priority queue is 0, and the highest queue is 7. You can specify
only one queue.
Mode
Global Configuration mode
Description
Use this command to map DSCP values to port egress queues. An egress
queue can have more than one priority value mapped to it, but you can
assign only one priority at a time with this command.
Note
QoS must be enabled on the switch and a port must be set to DSCP
trust before you can use this command. Refer to commands
"CLASS-MAP" on page 1701 and "NO AUTO-QOS VOICE | TRUST
DSCP" on page 1738.
Use the NO form of this command, NO MLS QOS MAP DSCP-QUEUE, to
return the DSCP value mappings to their default values.
Confirmation Command
"SHOW MLS QOS MAPS DSCP-QUEUE" on page 1770
dscp_value egress_queue
to